Skip to main content

Connecting and signing in

The connector is in limited access and is enabled per email address. Check that:
  • You signed in with the Covver account that was given access. The approval page shows the address after Signing in as.
  • Your email address is verified. An unverified account cannot connect. See sign in.
If both are correct and it still fails, your account does not have access yet. Contact Covver to request it.
Disconnect Covver Builder in your assistant’s connector settings, sign out of Covver in your browser, then connect again and sign in with the right account.
Reconnect from your assistant’s connector settings; you may be asked to sign in again. If the assistant then reports that the connector is not enabled for your account, access was turned off for that account.
Check that Covver Builder is turned on for the conversation, and mention Covver in your request (“create a Covver magazine…”). Starting a new chat after connecting also helps.

Photos and uploads

Chat attachments do not reach the connector. The assistant can see your image, but it cannot pass the file along. Ask for an upload link (“give me a link to upload my photos”), add the photos there, then tell the assistant they are uploaded.
The upload page accepts PNG, JPEG and WebP images up to 15 MB each. Convert other formats, such as HEIC or TIFF, and resize very large files before uploading.
When the assistant sends an image itself rather than through the upload link, the limit is 6 MB. Use the upload link for larger photos.
Wait until every photo shows Uploaded on the upload page, then tell the assistant so it looks at your library again. Uploaded photos also appear in your library in the Builder.
The page hit its photo limit (up to 6 stock photos and 3 AI-generated photos per page), no stock photo matched the search, or generation failed. Ask the assistant to fill that slot again, give it one of your own photos, or replace the placeholder in the Builder.
The preview updates when the connector changes a page. If you edited the magazine in the Builder afterwards, ask the assistant to refresh the preview.
The connector only creates drafts. The preview link is for checking your work, not for sharing with readers. Open the editor link and publish the magazine, then share it.

Pages and content

The layout engine fits content to the page and reports what did not fit. Ask the assistant to shorten the text, split it over two pages, or use a page style with more room for text.
Composing a whole issue replaces every page of the magazine, and composing a page or spread at an existing page number replaces that page. To add without replacing, say “add a new page at the end”. Before large changes, ask the assistant to work on a new magazine.
Magazines made with Covver’s earlier editor are not supported by the connector. Open them in Covver directly.
The connector only works with magazines owned by the account you connected. Check which account is connected and reconnect with the right one if needed.
A code lock needs exactly four digits, and a quiz lock needs both a question and an answer. Give those in your request.
Composing a full issue, generating photos, removing a background and replicating a reference design can each take from several seconds up to about a minute. Wait for the assistant to finish before sending the next request.

Still stuck

See the general troubleshooting page and the FAQ.